120 Minute Mechanical Timer & Hardware Kit

This very popular timer is used to replace OEM timers in Schumacher, Century, and other popular chargers. Easily installs with 4mm screws (included) through the charger panel and into the mounting plate on the timer. The screws are covered by the sturdy press-fit skirted knob. Wire terminals use .250" industry-standard solderless push-on connectors. No AC power is required to run this timer. No specialty tools required.

When oriented with the "OFF" position at 12 o'clock, this switch has a "HOLD" position (constant ON) when rotated counterclockwise to the 11 o'clock position.
Otherwise, when rotated clockwise to a set position, it will countdown back to the OFF position at 12 o'clock. A finish bell alerts you to the timer returning to the OFF position with a single ding.

Replaces

Schumacher Timer 0099000094, 0099-000094, 2299001548, 2299-001548
Snap-On Timer 2-14866
Century/Solar Timer 246-457-666, 246-515-666
Goodall Timer 51-245, 51-246, 51-248, 246-337-000, 246-167-000, 246-167-666

Note: Some of these OEM timers were 135 minute duration, which are no longer available. The 120 minute timer is now the standard replacement. A 120 minute timer dial label is included, should you wish to use it.

Features

• 120 Minute duration, with "HOLD" position.
• Mounts in charger panel with included M4 screws.
• Straightforward instructions and simple design allows easy installation. No special tools are required.

Special Mounting Note

Over the years, battery charger manufacturers have used versions of this timer that mounted with either M3 (3mm) or M4 (4mm) screws. This timer uses the larger M4 screws, which are supplied in the kit. If you are replacing a timer that used the smaller M3 screws, it will be necessary to increase the size of the mounting holes in the charger cabinet. You can open the holes with a small drill bit. 4mm, 5/32”, or 3/16” bits will all work.

Specifications

• .250" Push-on connectors.
• Switched Current Rating 13A/120VAC, 16A/250VAC
• Timer body - 1.71"H x 1.85"W x 1.04"D
• Stem - .70"L x 6MM (.236") Diameter

• 120 minute timer with "HOLD" position.
• Skirted press-fit knob with steel retainer insert.
• Mounting fasteners & hardware.
• Laminated 120 minute Dial Label.
• Instruction sheet.

Replaces

Features

Special Mounting Note

Specifications

Contents

Timers

Timer Kit - Mechanical 120 Minute w/"Hold" Position 1/4" (6 MM) D-Shaft 3/8" Threaded Sleeve Panel Mount 35 reviews

Timer Kit - Mechanical 120 Minute w/ "Hold" Position & Finish Bell, 1/4" (6 MM) D-Shaft, M4 Screw Panel Mount 23 reviews

Timer Kit - Mechanical 60 Minute 1/4" (6 MM) D-Shaft 3/8" Threaded Sleeve Panel Mount

Timer Kit - Mechanical 120 Minute w/"Hold" Position 1/4" (6 MM) D-Shaft 3/8" Threaded Sleeve Panel Mount

35 reviews

Timer Kit - Mechanical 120 Minute w/ "Hold" Position & Finish Bell, 1/4" (6 MM) D-Shaft, M4 Screw Panel Mount

23 reviews